shiftr
About
- Username
- shiftr
- Joined
- Visits
- 395
- Last Active
- Roles
- Member
Comments
-
I have the Erica case. The steel cases are much stronger than the plexi cases. The looks are personal I guess. I don't think there are cons..
-
and on CYM and HH the fine tune also doesn't work.
-
really nice! sure getting one!
-
Exciting!
-
The 3 mm plexi is on top of 10 mm standoffs.. So if you still have about 5 mm more than 13 mm from the board you are all right..
-
The link to the version I made is in the thread mentioned above.. But I suspect people did edit it for use with ponoko... Maybe people can share their version of my design
-
-
Happy new year and lot's of DIY fun again this year!
-
Are the oscillators synced every new beat or are they freeruning? If they are freerunning it's not strange that there is a click sometimes because the attack sometimes happens at the 'top' of the wave. Setting your attack to 1 instead of 0 should so…
-
I have one and also the drone lab.. I use them together with a mi sidekick.. Instant very complex modular sounds
-
I like one jullian! Looks like there is plenty space for drilling a hole next to the other hole.
-
Wow... Now it's getting really exciting!
-
In ableton live there is another solution to fetch the knobs... It's scales the movement of the pot with the value stored in memory. That way the pot always reacts directly without jumping. It works really nice. I guess you have to check it to s…
-
I think you can see stutter also as a kind of synthesis option. Would be cool!
-
Finally my LXR is not naked anymore. I initially wanted some funky fluor red as a top plate but the transmission from the green leds was a bit to low. Screen was ok though. So i went for clear instead. The design is really close to fcd72's design. T…
-
I think the leds will shine through really nice with white plexi. I like the vague light you get from it.
-
Looks nice in white!
-
What is it when you press SHIFT VOICE or SHIFT STEP? It seems to get in some mode similar but not totally to STEP.
-
I think it will be easy to solve with a flatcable...
-
Here is the design i made in Illustrator. I think it's ok but it's not tested yet. I started working from the PCB PDF and did some real life measurements to confirm some stuff and for the outputs. It's very similar to franks case. I alway borrow so…
-
@Altitude ? new header? So it's for the new boards and not for the old boards? Or a new header on the trigger PCB?
-
Does this go straight on the expansion header? Looks more like it needs a flatcable..
-
Does it need a bigger case for this?
-
So finally have some time to work on my own case again. I also haven't been keeping up with the firmware changes.Do any of the new functions ask for extra information on the frontpanel design?
-
Never trust me to sell an LXR as I won't let go of it ever
-
So that's only the left shoe? The right shoe is just out of the frame of the picture?
-
I did measure, virtual vs virtual.and i had some time and material left to measure real world vs real world. I hoped i could get the easy way out using your files but i'll have to do some more measuring
-
So can i conclude that the pdf posted by julian is right? I used the files from Frank to cut a case but it came out exactly as off as in the comparison. It must be the scaling from Franks laser cutter. I'm planning on making a new one on the basis …
-
Can i have a T-shirt with that?
-
It would be too cool if it would constantly emit a little smoke through the vent holes!.. :-D