@Altitude those are highly switches part no. PB6149L-13-102
Is it completely balls-hat crazy to fit those on the LXR board, i can see the the dimensions is 5,00 mm. vs. 5,08 in the pin spacing. And long the long legs on the higly switches could perhaps bent to fit in the other direction.
@Altitude those are highly switches part no. PB6149L-13-102
Is it completely balls-hat crazy to fit those on the LXR board, i can see the the dimensions is 5,00 mm. vs. 5,08 in the pin spacing. And long the long legs on the higly switches could perhaps bent to fit in the other direction.
yeah those switches are really nice. but for the LXR you should use another cap since the quantizer button caps are only ~5.3mm diameter opposed to the 8.6mm from the LXR buttons.
My last DIY experience was an LXR and I was waiting for the next one. I've never build an eurorack module before, I'm impatient to try. Thanks, It's very nice to begin the year with this.
I know its a long long shot but it would be great to get a panel PCB designed for 1/4" jacks with appropriate spacing for larger buttons. (as found on the LXR) This PCB could be an additional item in the shop.
I know the biggest modular market is euro, but the rest of the audio world uses 1/4" cables!
I know its a long long shot but it would be great to get a panel PCB designed for 1/4" jacks with appropriate spacing for larger buttons. (as found on the LXR) This PCB could be an additional item in the shop
I think an additional PCB is less trouble than an additional Frontpanel. I'd say this really depends on demand. Not too much work to do a bigger PCB. I'm just completely clueless about which type of jack to use there...
Julian, It's only 4 jacks so if there was an alternate PCB available, with the larger LXR buttons you could just leave solder pads on the PCB for the connections to the jacks. This way users / DIYers could adapt the circuit for whatever format jacks they needed! (1/4", Banana, etc.) As long as it connected down to the Main Penrose PCB.
Comments
Is it completely balls-hat crazy to fit those on the LXR board, i can see the the dimensions is 5,00 mm. vs. 5,08 in the pin spacing. And long the long legs on the higly switches could perhaps bent to fit in the other direction.
http://shop.sonic-potions.com/index.php?route=product/product&path=63&product_id=67
But I just found out I 'm missing some stupid 16 pin ribbon cable connectors for the power chords and have only 32 left in stock
So when the quantizer should be sold out I'll probably have more units ready around tuesday
might be a little out of tune because i added the penrose output with a cv sequence in a module that is not very precise.
Thank you, Julian, for the fast shipping and the nice extra!