Home › nightworxx › Comments
nightworxx
About
- Username
- nightworxx
- Joined
- Visits
- 2,532
- Last Active
- Roles
- Member
Comments
-
Garbled readings lead to a empty battery in the multimeter...
-
Will give you a call when i'm around.
-
Defintely - i'll be there tomorrow morning after 9 am… my cellphone number is still valid ;-)
-
I used a level 10 SONY 8GB SD card and it works fine…
-
Tested yesterday Penrose in combination with my RYO VC sequencer and a TH 4046 VCO and stumbled into this bug. But being honest i think this is more feature i like and will not update in the near future... Penrose is absolutely awesome !
-
Very nice!
-
So there is no coincidence at last, this can be ruled out so far.
-
Yep, but beware of the specs. Recoms are mostly used for upscaling DC-DC voltage recommendations. If you need more than one voltage and have to switch to AC power supplies they are ideal.
-
It's always a good rule of thumb to not use more voltage as required, as the excess will dissipate as heat.
-
Just one out of curiosity: do you plug into an interface or mixer ?Do you use a plain mono cable or a balanced / fake balanced cable ?Some interfaces not only do not like this.. i've seen issues in the past with very expensive interfaces, where thei…
-
Ok, you can count me in, This is exactly something i need !
-
These tacts are absolutely cool !
-
Merry christmas to you all folks and your families !Rock on...
-
in !
-
It looks to me like an issue of the LCD itself. I guess you may have to replace it...
-
Ingenious ! Very well done.
-
The function of the switches and LEDs is directly connected to the resistor networks around these. Check for weak soldering there, before you start any kind of replacing part by suspicions. Check all networks properly for too less solder or dull sol…
-
Sadly i just stepped out of the plane from Berlin...
-
Nice idea, thanks. Gotta check if i have some around here.!
-
Build mine, was pretty easy. Fastend my fresnells with transparent super-glue - was a bit tricky to get off the excess. But the key to success is patience and let the stuff dry up and due to the excellent powder-coating of the enclosure it was easy …
-
I guess it will be DHL, as i am short on time this and the following week. Next week i am in Berlin for a few days and unfortunately i have some preparation ongoing for a conference. -.-I fear our next meeting may not happen before the next music fa…
-
Girts +1…Muahhahahhhhaaaa, WANT !!!And i could pick up mine to speed things up… ;-)
-
YES !!!
-
??? i use the card slot of my Macbook Pro with Finder without any issues...
-
Hey Girts, is it allowed to drool ?
-
Still 3 more weeks until vacation…this sucks !
-
Have a nice week !
-
But this feature would be extremely sexy !
-
I made the experience that short one-shot samples with zero offset are defintely the best ones for the usage in the LXR.
-
Where do these outputs go: mixer ? If yes, then routed to a bus ? If yes, are there bypassed FX on the sends ? Interface ? Buspowered by USB?