› ›

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

Sign In Register

billy

About

Username
billy
Joined
Visits
9
Last Active
Roles
Member

Comments

  • Yeah, it has to be the firmware. I'm going to go back over that to see if I did something wrong. 
    in LED - All lit but no chase (Step 20 in build instructions) Comment by billy April 2016
  • Okay so I connected a wire from pin 9 to the resistor in the corner and another wire from pin 9 to pin 10 of that IC in the corner. Then, I also connected a wire from pin 12 to the switch and another wire from pine 12 to that resistor network above …
    in Lost solder pad Comment by billy March 2016
  • Okay, thank you.  It seems that it is the pads where pin 9 and 12 of the IC labelled U12 that have been removed. I’m not completely sure how to read the schematic but it seems that pin 9 connects to a node that splits with one direction going to pin…
    in Lost solder pad Comment by billy February 2016