newnoise

Comments

• Hi Julian, okay that sounds better than I expected. I will have another look at it tonite and if I don't succeed I will gladly send the mainboard to you, thanks a lot for the offer! I will contact you via the contact form then, so you can give me …

  in Added Trigger Extension, cannot enter steps anymore Comment by newnoise May 2014
• should I order a new mainboard?

  in Added Trigger Extension, cannot enter steps anymore Comment by newnoise May 2014
• Okay, so for the continuity: PIN 1 and PIN 2 have continuity to the bottom side (in the picture above) of C12. From PIN 3 upwards they don't. Measuring the voltage between PIN 1 and bottom Side of C12 is 1.6V, between PIN 2 and C12 0V ... I'm afra…

  in Added Trigger Extension, cannot enter steps anymore Comment by newnoise May 2014
• Ok, I will do that. Not before friday though, no time before, I will post here when I checked it!

  in Added Trigger Extension, cannot enter steps anymore Comment by newnoise May 2014
• I rechecked every pin on the chip for 32 times (estimated ) and really cannot find any of these connected anymore. Can I check something else? This is so unnecessary, aah.

  in Added Trigger Extension, cannot enter steps anymore Comment by newnoise May 2014
• The computer does not recognize the LXR. Which I suppose is bad ... I rechecked both spots, they really seem fine to me now. I tried to make another picture, but I dont think its good enough. https://dl.dropboxusercontent.com/u/7542095/P5062534.png…

  in Added Trigger Extension, cannot enter steps anymore Comment by newnoise May 2014
• Yes. I will do that tonite, or maybe tomorrow morning, because I'm not sure when I will be home! I really appreciate your support!

  in Added Trigger Extension, cannot enter steps anymore Comment by newnoise May 2014
• Will check that tonite when I'm home from work again.

  in Added Trigger Extension, cannot enter steps anymore Comment by newnoise May 2014
• hi julian, I was able to remove it with just a needle, and I found another spot on the chip which had a solder blob on it (I marked both in the new picture: https://dl.dropboxusercontent.com/u/7542095/lxr.png) Guess you should NOT do those solderin…

  in Added Trigger Extension, cannot enter steps anymore Comment by newnoise May 2014
• Oh, you're right. Dammit. Hope this didnt fry the Mainboard? I got this one here: http://www.elektronik-24.de/images/articles/882_2a780f549f7f365724d01b0c514cec40_5.jpg Thanks

  in Added Trigger Extension, cannot enter steps anymore Comment by newnoise May 2014
• Hi julian, I'm very sure that I soldered all the pins correctly. But here is a picture, I hope it is good enough: https://dl.dropboxusercontent.com/u/7542095/P5062524.png What I also cannot do ist a firmware upgrade. Tried to do it to reset all se…

  in Added Trigger Extension, cannot enter steps anymore Comment by newnoise May 2014
• Hi, no unplugging does not help. Pictures comes later when I'm at home. Thanks

  in Added Trigger Extension, cannot enter steps anymore Comment by newnoise May 2014
• About 100€.

  in Custom enclosure Comment by newnoise May 2014
• Hi Just, this looks supercool! Can you maybe also post some Pictures of the back and the bottom? And the size of the wooden parts? Thanks a lot! noise

  in Custom enclosure Comment by newnoise April 2014