Home › Speelycaptor › Comments
Speelycaptor
About
- Username
- Speelycaptor
- Joined
- Visits
- 6
- Last Active
- Roles
- Member
Comments
-
Hi, i found now a Psu with 9 volt and 600mA and it solved the issue with the potmeter noise/ undesired change of parameters. :-). Those 100mA made all the difference and my LXR runs smooth now and it's joy to use. Will now focus on the creative si…
-
not yet, but i'll buy a decent one on monday. The one i'm currently using is a bit "weak on the chest"
-
thx Julian, i'll try this tonight.
-
Thanks for the link, goes straight to my christmas wishlist...
-
not that i am really qualified on the tech side, but i had similar display problems with the unit booting up okone time, not at all the next time, booted up with blank display and all LEDs on or the display ended up displaying weird characters after…
-
i only have a cheapo multimeter without continuity test, but i can do it at work. The LXR has been running fineso far . left it running over night with the sequencer running and i'm in love with the sound.
-
hi FCD, have been eyeing with the Shruti, but first i have to get rid of some of my synths to get some space for new gear- and i have 5 hardware mono synths already. For now i'll use my new aquired soldering skills to service my existing gear and p…
-
It's working now ! Tried the before mentioned power supply just for fun and now the chaselight is running fine for 5 minutes without crashes. Weeee" :-)) so glad the solution was that simple. Now off into the studio...
-
Been diggin' in the bin but only have 9v standard "boss" type psus lying around. Closest i have is a 9v /560mA 5.04 VA. Will buy one tomorrow and report back. Thanks for the support Nightworxx! Much appreciated
-
While i waited for my roomate, who has a card reader, i started fixing the step buttons with tape and when trying to power the Lxr, it wouldn't start at all. I measured the voltage and found that i only had 3,4 volt. After a couple of power cycles t…
-
Build is finally done. Had my soldering work reviewed by some of our technicians under the microscope and they were satisfied . I ran into one little issue at the very end, as i inserted the last ICs the wrong way. Thanks to Julian's note in the…
-
Thanks for the quick answer :-) - i'll try that and report back.
-
I should add that the crash happend in the first place after i pressed some of the step buttons while the sequencer was running . Before soldering in the display and inserted the Sd card. Also checked that the tempo is set.
-
Thx, i studied the assembly again and figured this out too. I was just confused as some pictures further on in the guide showed still the older pcb revisions with all the resistors soldered in. Better safe than sorry :-) Am about to solder the res…