Dennes
About
- Username
- Dennes
- Joined
- Visits
- 6
- Last Active
- Roles
- Member
Comments
-
Gesendet von meinem XT1039 mit Tapatalk
-
Haha I was totally focused on hardware or soldering issues But now everything works fine and the lxr is an amazing machine
-
Thanks for your support
-
Ohhhh shiiit Just reflashed it and everything works shit
-
My psu is definitively ok and the bootloader works too. When the bootloader works, then the avr should be ok?
-
today i changed the caps and the quarz, but everything ist still the same. Maybe there is a problem with the AVR itself?
-
At work i have ha big varierity of electronic components, so at first i will look there whether i can find the caps and the quarz. Caps will be there for sure but exactly this quarz could be a problem. I will post here if I found them The support …
-
I soldered both out and messured them. tomorrow i will solder a new 22p in, maybe something happens
-
no i dont switched anything, i soldered both caps like on the pcb shown. i just checked the two caps, the 100n is ok but the 22p has actually around 60p. Is this toleranz ok for the function?
-
I have neither an oscilloscope nor an AVRburner at home, but only at work. Iam probably not allowed to use it for this problem I took some pictures of the Mainboard solder joints and and the quarz area.
-
The LCD works exactly the same way without the ics, so I think they are fine. The LCD changes every three seconds between theses scrambled numbers and 0.23 Actually I "beeped" (durchgangsprüfer?) the connection between the pcb and the mainboard the…
-
The LEDs dont light up very often. It only happend around three times, especially when the mainboard ist not connected. The soldering on the connector looks so bad because of my lamp standing on my table. When I took the pictures only this lamp was …