grmmsk
About
- Username
- grmmsk
- Joined
- Visits
- 0
- Last Active
- Roles
- Member
Comments
-
AHHAAHAHAH! J. got back to me and explained that due to new co-workers the shippinf process got mixed up quite a bit and it seems that they have send me now 2 non-programmed mainboards. A third one shall be on it's way soon. We all hope that solve…
-
Well, that's of course a real pity, but i am glad i am not alone with this issue. I really hope WE can figure out how to find out where the problem is coming from and how to fix it. A good thing is that i got a quick response from Julian this ti…
-
Hurray, today i finally got the new mainboard! (Thank you Julian!). UNFORTUNATELY it behaves exactly like the old one (see above). On start up all seems fine, but START doesn't start anything but lighting up (not flashin) the START LED.It gets stu…
-
Well, it's fine in so far that julian got back to me. he has been too busy with "familiar" things before. We had a friendly email chat and he pointed out one more thing i could check. I have checked that the NRST pin of the mainboard is HI when the …
-
Hi and thanks for your resonance, zabox. It's awfully quiet here. - No, i am not able to set steps in the sequencer. - Yes, the BPM is set higher than zero. I have now also tested the USB connection also with a microsoft computer (before only wit…
-
Good news(?), i did some more testing according to the LXR Troubleshooting webpage: The 74HC165 ICs are responsible for reading the buttons. If some or all of the buttons are not working, it is most likely due to an error with those ICs. check if …
-
bad news, when i was checking if the LXR is visible as a USB device on my computer, it wasn't recognized. the power pins measured 3.29V and again all the socket pins to the main board measure continuity...also all pins of the AVR to the socket meas…
-
Good morning to y'all (nobody?), but frustrating for me, after giving the updating process a long time run, nothing has changed from my previous attempts. had to abort the updating (stuck at "updating...(1/2) and everything behaves as described abo…
-
So now, i have been trying to update the firmware from a 2GB toshiba SD card. The updating progress is as slow as before, running over an hour now, with the progress led bar doing it's progression and the display reading: updating..(1/2). I wonder h…
-
Is it set to voice mode, I think you don't see any running lights in perf and step mode... not sure! Thanks for your reply mixrasta. Yes, it's set to voice mode, after booting up that has been the default setting: voice mode / voice 1.
-
Now, after over an hour of UPDATING...(1/2) i've pulled the plug, with the result that after boot, it doesn't say "can't read kits" anymore. GOOD! unfortunately pressing START still doesn't result in a running chaselight...=( What to do? What to…
-
Now, i've soldered up the display. seems like i'm running v.37, but i still have no running chaselight as described in the 20th step of the assembly manual...=( I've tried updating the firmware (bootloader v.1.2) it says "SD card OK" or the like …