Trigger IO Configuration Page

supercollider

My aim is to change the resolution of the clock, currently when synced to my modular, the LXR advances sixteen steps per four the modular advances.

The manual states that I enter this configuration page by SHIFT + LOAD, then pressing the AEG button to enter the Trigger IO Settings. However, pressing the AEG button does nothing after entering the SHIFT + LOAD menu. Does someone have a suggestion regarding this?

Thanks

jbdiver

I found these instructions confusing too. However, this key sequence is not needed. Just hit SHIFT+LOAD to get to the menu. Then use the encoder to scroll to cki (clock input) or co1/co2 (clock outputs) to change the clock division.

supercollider

Thanks for the tip, I found the settings!