›

Questions about assembly guide for board revision 0,52 ( how many led resistors are needed)

SpeelycaptorSpeelycaptor
edited November 2013 in General
Hi, i'm almost done with my build, but need some infos about the Led resistors. My kit didn't contain them. I already found that i used the old assembly guide and that the new one includes the "linked resistor" chips, that came with my kit. In the instructions there is only one Led resistor named, but the picture of the guide has lots of them soldered. I am assuming that i have the latest board revision, as it looks different om the new and old assembly guide. Did anybody already finished a rev 0,52 build and could clarify this?

Thx, Mike

Comments

  • tsvtsv
    Yeah those have been replaced by the resistor arrays. No R LED's needed. I was confused too!


    Sent from my iPhone using [URL=http://tapatalk.com/m?id=1]Tapatalk[/URL]
  • SpeelycaptorSpeelycaptor
    Thx, i studied the assembly again and figured this out too. I was just confused as some pictures further on in the guide showed still the older pcb revisions with all the resistors soldered in. Better safe than sorry :-)

    Am about to solder the resistor networks in and then i have only the Leds and the display left. Can't wait to be finished and hear this baby pumping. :@)
  • tsvtsv
    Cool! 
  • julianjulian
    R_LED are not needed (only R7)
    I should clarify this more in the guide.
    same for the pictures.
    I forgot to take some pictures during the build and had to recycle some of the old build instruction.
Sign In or Register to comment.